Belegarth
http://board.belegarth.com/

Arm Accessories
http://board.belegarth.com/viewtopic.php?f=107&t=42421
Page 1 of 1

Author:  Kazumi Sensou [ Fri Dec 11, 2015 5:37 pm ]
Post subject:  Arm Accessories

hello, so i have recently decided to join up with Belegarth and i want to be legit with my garb in case i wind up at an event.

my question is if i have garb and leather shoulder and bracers that don't meet the 3/4 thickness requirements will that mean i would have to take those off for an event?

Author:  Kaladin [ Mon Dec 28, 2015 10:09 pm ]
Post subject:  Re: Arm Accessories

Sensou wrote:
hello, so i have recently decided to join up with Belegarth and i want to be legit with my garb in case i wind up at an event.

my question is if i have garb and leather shoulder and bracers that don't meet the 3/4 thickness requirements will that mean i would have to take those off for an event?


3.5. The minimum thickness for leather Armor is 3/16 inch (0.45 cm). The minimum thickness requirement can be achieved by layering up to two pieces of thinner leather.

Just add and extra layer underneath the said armor and make sure it conforms to the rest of the rules. I'm not sure where you got 3/4.

Or you can modify it to obviously only be garb like add fur or something. Your call really.

Page 1 of 1 All times are UTC - 6 hours
Powered by phpBB © 2000, 2002, 2005, 2007 phpBB Group
http://www.phpbb.com/